QA-T43
Common : 05 - Factory reset re-enables Access Point
OBJECTIVE
Overview
Additional detail to help the purpose of the test be clear:
This test makes sure that resetting the Edge Device back to its factory set, the Access Point turns back on. This is important because this is part of the factory reset fail safe.
Critical Criteria of Test(CCT)
Additional detail to help the purpose of the test be clear:
This test makes sure that resetting the Edge Device back to its factory set, the Access Point turns back on. This is important because this is part of the factory reset fail safe.
Critical Criteria of Test(CCT)
- Factory resetting the Edge Device will turn the Access Point back on at boot
PRECONDITION
Before starting the test script you will need to do the following pre-test setup:
- The tester has a basic understanding of Tulip Terminology
- The Edge Device is in clear state/in factory reset state
- The tester has access to tulip 1Password
- The Edge Device has an Access Point connected before
- The Edge Device's Access Point has been turned off
- The tester starts from the Device Portal dashboard page
Covers
routes