QA-T1010

Verify that Tulip Light Kit and Andon light is functioning.

Critical criteria of test (CCT):

• You can use Light Kit to control the Pick to Light led strip (changes made in the app should be reflected by the light strip)
• Andon light could be controlled through IO Gateway or Edge devices (changes made in the app should be reflected by the Andon light)

For Light Kit:
- You have a Light Kit
- You have a running, registered IO Gateway or Edge device (Edge IO or Edge MC)
- You have access to the Device Portal of the IO Gateway or Edge device
- 'Light Kit' driver is enabled on the Device Portal
- Light Kit is connected to the IO Gateway or Edge device with USB
- No other devices are connected to the IO Gateway or Edge device
- Light strips are connected to the Light Kit (ports 1 and 2)
- You have access to 'Driver Unit Test' app in qa.tulip.co

For Andon light (ONLY DO THESE SETTINGS AFTER FINISHING THE TEST FOR LIGHT KIT):
- You have an Andon light
- You have a running, registered IO Gateway or Edge IO
- Andon light is connected to the IO Gateway or Edge IO
- No other devices are connected to the IO Gateway or Edge IO
- You have access to 'Driver Unit Test' app in qa.tulip.co

NOTE: 
Wiring Andon Light to IO Gateway:
-- Use a 10-pin block and wire the gray wire to the ground, green to 3 and red to 4
-- Plug the block into the OUTPUT serial slot

Wiring Andon Light to Edge IO:
The Andon wires should be connected by the following order:
RED --> GPOUT PIN 4
GREEN --> GPOUT PIN 3
GRD --> GPOUT GRD

You can't connect an Andon light to an Edge MC!