QA-T91

To ensure break beam device events can be read by sensor and also receive it on factory side.


critical criteria of test (CCT)

• Break beam events are read in factory
• Break beam sensor

I/O Gateway:

1. Set up break beam in driver unit test app
2. Have break beam sensor
3. GPIO connection (Wires, how to - https://support.tulip.co/en/articles/2291312-5-setting-up-the-break-beam-sensor)

NOTE: The link above is for wiring the Break Beam for use with Edge IO.
To wire it to use with the IO Gateway:
-- Wire the 9-pin GPIN connector same as in the picture in the link (with Blue and black wires)
-- Plug it in to the 'A' serial slot in the IO Gateway
-- Wire the GPOUT connector to a 10-pin connector with the brown wire in the 4th slot
-- Plug it into OUTPUT serial slot of the IO Gateway

NOTE: This test cases is not for use with Edge MC